Have you been wondering about this project?
Well, I finished them and have a grandchild to model for the picture, so here it is!
I am very happy with how they turned out.
|
Gavin on one of the new booster seats. |
|
I started with 2 large cookie cans, 1 yard of oilcloth and it was just about the right amount to cover 2.
I also used masking tape, batting and E6000 glue.
In case you are wondering if a cookie can is sturdy enough for a child to sit on, yes they are!
My fully grown daughter tried sitting on one and it held her just fine,
Yes, I should of taken a picture of Nina on the cookie can! |
|
First, I covered the cans with batting scraps and some old baby things that Nina was getting rid of. (you all know I do things thrifty whenever possible.) |
I am sure there are much better tutorials to upholster at many other blogs, this is just the simple way I did them. You might want to look into more detailed instructions than mine........
|
cut 2 circles about an inch bigger than the cans.
Also cut a long piece about an inch bigger on all edges to go around the base.
I used pins but just in the very edge so the pin-holes would not show |
|
I machine-sewed the first circle to the long piece, and also used the machine to attach the 2 ends of the long piece.
Then I turned it right side out and put it on the cookie can.
I used more masking tape to pull the oilcloth tight around the can.
Then I attached the bottom oilcloth piece with E6000 glue to seal everything in. |
|
a bear tries the chair |
|
just the booster.
My photos are not good but I think you can get the idea.
These are not approved by the child safety commission but I think they are fine for older toddlers .
I got the oilcloth at Joanns Fabric store in my town. |